Web page 193 CHASSIS Front FORK SETTING Components Choosing SET Length • Entrance fork spring “1” 1. Place a stand or block under the engine to place the rear wheel I.D. Page 192 CHASSIS CHASSIS DRIVE AND https://culturahistorica.net [https://culturahistorica.net] REAR WHEEL Front FORK SETTING SPROCKETS SETTING Parts The entrance fork setting ought to be made Selection of THE SECONDARY relying on the rider’s feeling of an Reduction RATIO (SPROCKET) Part name Size Part number actual run and the circuit situations.
HANDLEBAR HANDLEBAR Removing THE HANDLEBAR 2 Nm (0.2 m kg, 1.Four ft lb) Order Half identify Q’ty Remarks Number plate Take away the band only. Page 171 SWINGARM DISASSEMBLING THE SWINGARM Order Part title Q’ty Remarks Relay arm Connecting rod Collar Oil seal Thrust bearing Bushing Oil seal Bearing Consult with elimination section. Page 148 Front BRAKE AND alssal REAR BRAKE DISASSEMBLING THE BRAKE Master CYLINDER Order Part identify Q’ty Remarks Front Rear Brake master cylinder cap Diaphragm Reservoir float Push rod (entrance) Brake grasp cylinder boot Circlip Use an extended nose circlip pliers.
REAR SHOCK ABSORBER REAR SHOCK ABSORBER Removing THE REAR SHOCK ABSORBER Order Part name Q’ty Remarks Hold the machine by inserting the acceptable stand Confer with “Dealing with Note”. Page 141 Front WHEEL AND alssal REAR WHEEL Removing THE REAR WHEEL Order Part name Q’ty Remarks Hold the machine by putting the acceptable stand online slots usa Check with “Handling Note”.
With the camcorder on, hold D pressed down for 78win more than 2 seconds. Playing Back Video Playback Playback Playing Back Video Operating modes: 1 Press T.
• You can too press and hold on the wireless controller for greater than 2 seconds to switch between shooting and playback mode. • It’s also possible to press M on the wireless controller. • Canon LEGRIA CD-ROM. Nut (rear wheel axle) Rear wheel axle Drive chain puller Rear wheel Check with elimination part. Stopper ring Discuss with removing part. Contact needs to be made Bolt (brake disc): 105 Nm (10.5 m•kg, slots casino 75 only with the outer race. Page 157 Front FORK Handling Note Removing THE ADJUSTER 2.
Remove: 1. Drain the outer tube of its entrance • Inner tube “1” fork oil at its prime.
Page 164 HANDLEBAR Removing THE BRAKE Master Installing THE HANDLEBAR CYLINDER 1. Install: • The handlebar upper holder should 1. Remove: alssal • Handlebar decrease holder “1” be installed with the punched mark • Brake master cylinder bracket “1” • Washer “2” “a” ahead. Web page 173 SWINGARM Installing THE SWINGARM 1.
Set up: Apply the molybdenum disulfide • Bushing “1” grease on the bolt. Slow-speed-circuit passage Hard respiration Clogged → Clean. Clean or replace spark plug. IGNITION SYSTEM IGNITION SYSTEM INSPECTION STEPS Use the next steps for checking the potential for the malfunctioning engine being attributable to ignition system failure and for checking the spark plug which will not spark.